Crack-Rite 2120 Installation Guide download pdf

COMMERCIAL GRADE PL 500 HOT APPLIED CRACK & JOINT SEALANT

INSTRUCTIONS

PL 500 Type I Meets The Following Specifications:

Application Temperature Range 370F to 390F (188C to 200C)

Maximum Heating Temperature 390 F (200 C)

Softening Point 190F min. (88C) min.

Cone Penetration 77F (25C) 90 max

Resilience 30-60%

Bond Passes 5 cycles

Specific Gravity 1.14

IMPORTANT: Read entire label before using / applying product:

 Protective apparel is recommended with application of PL 500 Hot Applied Crack Filler.

The extremely hot material WILL cause severe burns upon contact with skin.

 Gasses given off by this product during heating are combustible – AVOID OPEN FLAME!

 Avoid breathing vapors. Heated asphalt may emit hydrogen sulfide (H2S). Breathing

concentrated gas in asphalt vapor may be fatal.

 Use with adequate ventilation. Wash thoroughly after handing.

APPLICATION INSTRUCTIONS

CLEAN SURFACE: Sweep all dirt and debris from surface. For cracks and joints with

vegetation you must remove the vegetation prior to applying. Air blowing the cracks with high

compressed air is recommended.

MELTING: Mix PL 500 Hot Applied Crack Filler in an oil-jacketed kettle or direct fire kettle

with an agitator to specified temperature.

NOTE: NEVER EXCEED MAXIMUM HEATING TEMPERATURE. Overheating could cause

material to gel within the application equipment. Immediately begin removal and discard

material if it begins to show signs of increased viscosity accompanied by stringiness. Melt

only enough material to be used within an 8-hour period. Additional material may be added

as sealant is withdrawn / applied.

FIRST AID: IN EYE: Immediately flush with large amounts of water for at least 20 minutes.

Immediately seek medical attention. HOT MATERIAL ON SKIN: Cool the burn area with

cold water or cold pack. DO NOT attempt to remove the material from the skin. Immediately

seek medical attention. ON SKIN: Wash thoroughly with soap and warm water. IF

INHALED: Remove person from exposure. If breathing has stopped or is difficult, administer

artificial respiration or oxygen as needed. Seek medical aid. IF INGESTED: Do not induce

vomiting. Seek medical aid immediately.

ATTENTION: Empty containers may retain material residues. Dispose of empty container in

accordance with local, state, and federal regulations based upon chemical composition of

contents.

1 2 3

Summary of Contents

Page 1

COMMERCIAL GRADE PL 500 HOT APPLIED CRACK & JOINT SEALANT INSTRUCTIONS PL 500 Type I Meets The Following Specifications: Application Temperature

Page 2

WARRANTY: There are no express warranties which extend beyond the description on the face hereof. MANUFACTURER DISCLAIMS ANY IMPLIED WARRANTIES OF ME

Page 3

NOTA: NUNCA EXCEDA LA TEMPERATURA MÁXIMA DE CALEFACCIÓN. El recalentamiento puede causar el material de gel dentro del equipo de aplicación. Comenzar

Comments to this Manuals

No comments

Crack-Rite 2120 Installation Guide

Browse online or download Installation Guide for Unknown Crack-Rite 2120. Crack-Rite 2120 Installation Guide User Manual

Summary of Contents

Comments to this Manuals